Aaru Report for S31B0811 USB DISK 1100

USB characteristics:
Manufacturer: SMI Corporation
Product: USB DISK
Vendor ID: 0x090c (Silicon Motion, Inc. - Taiwan (formerly Feiya Technology Corp.))
Product ID: 0x1000 (Flash Drive)

ATAPI characteristics:
ATAPI device
Supported ATA versions: ATA/ATAPI-4
Maximum ATA revision supported: Minor ATA version not specified
Parallel ATA device:

ATAPI Direct-access device
Device shall set DRQ within 3 ms of receiving PACKET
ATAPI device uses 12 byte command packet
Device capabilities:
Command set and features:

SCSI characteristics:
Vendor: S31B0811
Product: USB DISK
Revision: 1100
Device is connected and supported.
Direct-access device
Device does not claim to comply with any SCSI ANSI standard
Device does not claim to comply with any SCSI ECMA standard
Device does not claim to comply with any SCSI ISO/IEC standard
Device is removable
Device contains an Access Control Coordinator
Device supports protection information
Device contains an embedded enclosure services component
Device contains or is attached to a medium changer
Device supports request and acknowledge handshakes
Device supports 16-bit wide SCSI addresses
Device supports 32-bit wide data transfers
Device supports 16-bit wide data transfers
Device supports linked commands
Device implements RESET as a soft reset
Device supports implicit and explicit asymmetrical access
Device supports only ST clocking
Device supports MODE SENSE (6)
Device supports MODE SENSE (10)
Device supports MODE SENSE subpages

Device has 8028160 blocks of 512 bytes each
Device size: 4110417920 bytes, 4 Gb, 3.83 GiB
Medium type code: 00h
Device supports READ CAPACITY (10) command.
Device supports READ (10) command.
Device supports READ (12) command.

SCSI mode sense pages:
Mode Contents
MODE page 01h SCSI Read-write error recovery page:
Drive will repeat read operations 3 times
Drive will repeat write operations 128 times
MODE page 05h SCSI Flexible disk page:
Transfer rate: 5000 kbit/s
16 heads
7872 cylinders
63 sectors per track
512 bytes per sector
Write pre-compensation starts at cylinder 0
Write current reduction starts at cylinder 0
Target shall wait 50 seconds before attempting to access the medium after motor on is asserted
Target shall wait 300 seconds before releasing the motor on signal after becoming idle
Drive needs to do 1 step pulses per cylinder
Medium rotates at 360 rpm
Pin 34 is unconnected
Pin 4 is unconnected
Pin 2 is unconnected
Pin 1 is unconnected
MODE page 1Bh SCSI Removable Block Access Capabilities page:
Drive supports 1 LUNs
MODE page 1Ch SCSI Informational exceptions control page:
Informational exceptions are enabled
Generate no sense on informational exceptions
Timer interval is 2800 ms