Aaru Report for
HL-DT-ST
DVDRRW GWA-4166B
1823
ATAPI characteristics:
ATAPI device
Model: HL-DT-STDVDRRW GWA-4166B
Firmware revision: 1823
Supported ATA versions: ATA-2 ATA-3 ATA/ATAPI-4 ATA/ATAPI-5
Maximum ATA revision supported: Minor ATA version not specified
Parallel ATA device:
PIO timing mode: 2
DMA timing mode: 2
Advanced PIO: PIO0 PIO1
Multi-word DMA: MDMA0 MDMA1 MDMA2
Ultra DMA: UDMA0 UDMA1 UDMA2 (active)
ATAPI CD-ROM/DVD/etc device
Device shall set DRQ within 50 µs of receiving PACKET
ATAPI device uses 12 byte command packet
Device capabilities:
IORDY is supported and can be disabled
DMA is supported
At minimum 120 ns. transfer cycle time per word in MDMA, 120 ns. recommended
At minimum 120 ns. transfer cycle time per word in PIO, without flow control
At minimum 120 ns. transfer cycle time per word in PIO, with IORDY flow control
Command set and features:
28-bit LBA is supported
SCSI characteristics:
Vendor: HL-DT-ST (Hitachi-LG Data Storage, Inc.)
Product: DVDRRW GWA-4166B
Revision: 1823
Device is connected and supported.
CD-ROM/DVD/etc device
Device claims to comply with ANSI X3.408:2005 (SPC-3)
Device does not claim to comply with any SCSI ECMA standard
Device does not claim to comply with any SCSI ISO/IEC standard
Device is removable
Device supports setting Normal ACA
Device supports LUN hierarchical addressing
Device does not support asymmetrical access
Device supports only ST clocking
Device supports MODE SENSE (10)
Device supports MODE SENSE subpages
SCSI mode sense pages:
Mode |
Contents |
MODE page 01h
|
SCSI Read error recovery page for MultiMedia Devices: Drive will repeat read operations 30 times All available recovery procedures will be used. Recovered errors will not be reported. Unrecovered ECC errors will return CHECK CONDITION.
|
MODE page 05h
|
SCSI Flexible disk page: Transfer rate: 16836 kbit/s 10 heads 8192 cylinders 0 sectors per track 0 bytes per sector Write pre-compensation starts at cylinder 0 Write current reduction starts at cylinder 32 Drive steps in 15000 μs Target shall wait 0 seconds before attempting to access the medium after motor on is asserted Target shall wait 0 seconds before releasing the motor on signal after becoming idle Drive needs to do 1 step pulses per cylinder Pin 34 is unconnected Pin 4 is unconnected Pin 2 is unconnected Pin 1 is unconnected
|
MODE page 08h
|
SCSI Caching mode page: Write-cache is enabled Drive does not distinguish between cached read data Drive does not distinguish between cached write data No pre-fetch will be done
|
MODE page 0Dh
|
SCSI CD-ROM parameters page: Drive will remain in track hold state 32 seconds after a seek or read Each minute has 60 seconds Each second has 75 frames
|
MODE page 0Eh
|
SCSI CD-ROM audio control parameters page: Drive will return from playback command immediately Output port 0 has channels 0 at maximum volume Output port 1 has channels 1 at maximum volume
|
MODE page 1Ah
|
SCSI Power condition page: Standby timer Z is set to 10000 ms Idle timer A is set to 30000 ms
|
MODE page 1Ch
|
SCSI Timer & Protect page: Drive will remain in same status a vendor-specified time after a seek, read or write operation
|
MODE page 1Dh
|
Undecoded
|
MODE page 2Ah
|
SCSI CD-ROM capabilities page: Drive can play audio Drive can read sectors in Mode 2 Form 1 format Drive can read sectors in Mode 2 Form 2 format Drive supports multi-session discs and/or Photo-CD Drive can read digital audio Drive can continue from streaming loss Drive can read Media Catalogue Number Drive can read ISRC Drive uses a tray Drive can lock media Drive is not locked, media can be ejected and inserted Drive can eject media Each channel can be muted independently Each channel's volume can be controlled independently Drive supports 255 volume levels Drive has 2048 Kbyte of buffer Drive's maximum reading speed is 7056 Kbyte/sec. Drive's current reading speed is 7056 Kbyte/sec. Drive can read and write CD-R Drive supports reading CD-R packet media Drive can read and write CD-RW Drive can read DVD-ROM Drive can read and write DVD-R Drive's current writing speed is 4234 Kbyte/sec. in CLV mode Drive supports writing at 5644 Kbyte/sec. in CLV mode Drive supports test writing Drive can read both sides of a disc Drive supports DVD CSS and/or DVD CPPM Drive supports buffer under-run free recording
|
MODE page 31h
|
Unknown mode page
|
MODE page 32h
|
Unknown mode page
|
SCSI CD-ROM capabilities:
Drive can continue from streaming loss
Drive can eject media
Drive can lock media
Drive can play audio
Drive can read and write CD-R
Drive can read and write CD-RW
Drive can read and write DVD-R
Drive can read both sides of a disc
Drive can read digital audio
Drive can read DVD-ROM
Drive can read ISRC
Drive can read Media Catalogue Number
Drive can read sectors in Mode 2 Form 1 format
Drive can read sectors in Mode 2 Form 2 format
Drive has 2048 Kbyte of buffer
Drive is not locked, media can be ejected and inserted
Drive supports 255 volume levels
Drive supports buffer under-run free recording
Drive supports DVD CSS and/or DVD CPPM
Drive supports multi-session discs and/or Photo-CD
Drive supports reading CD-R packet media
Drive supports test writing
Drive supports writing at 5644 Kbyte/sec. in CLV mode
Drive uses a tray
Drive's current reading speed is 7056 Kbyte/sec.
Drive's current writing speed is 4234 Kbyte/sec. in CLV mode
Drive's maximum reading speed is 7056 Kbyte/sec.
Each channel can be muted independently
Each channel's volume can be controlled independently
SCSI MMC features:
2048 bytes per logical block
Drive can do a test writing in Session at Once Mode
Drive can do a test writing in Track at Once Mode
Drive can do a test writing with DVDs
Drive can eject media
Drive can format media into logical blocks
Drive can lock media
Drive can overwrite a SAO track with another in CD-RWs
Drive can overwrite a TAO track with another in CD-RWs
Drive can read and write DVD+R
Drive can read and write DVD+R DL
Drive can read and write DVD+RW
Drive can read CD-ROM
Drive can read DVD
Drive can return CD-Text from Lead-In
Drive can write CDs in Session at Once and in Raw Modes:
Drive can write CDs in Track at Once Mode:
Drive can write user provided data in the R-W subchannels in Session at Once Mode
Drive claims capability to read all CD formats according to OSTA Multi-Read Specification
Drive has 256 volume levels
Drive has an analogue audio output
Drive is to report drive serial number
Drive shall report Read/Write Error Recovery mode page
Drive supports DVD CPRM version 1
Drive supports DVD CSS/CPPM version 1
Drive supports set/release of PWP status
Drive supports the SWPP bit of the Timeout and Protect mode page
Drive supports writing DVD-R and DVD-RW
Drive supports zero loss linking in Session at Once Mode
Drive supports zero loss linking in Track at Once Mode
Drive supports zero loss linking writing DVDs
Drive uses a tray
Drive uses ATAPI interface
Tested media:
Information for medium named "Audio CD"
Medium type code: 02h
Drive recognizes this medium.
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ CD command with LBA addressing with this medium
Device can use the READ CD command with MM:SS:FF addressing with this medium
Device can use the PLEXTOR vendor READ DVD (RAW) command with this medium
Device can report the C2 pointers when reading from this medium
Device can correct subchannels when reading from this medium
Device can read the Table of Contents from this medium, without processing it
Device can read the first track's pregap data
Device can read the P to Q subchannels from this medium
Device can read the P to Q subchannels from this medium reporting the C2 pointers
Device can read the R to W subchannels from this medium
Device can read the Table of Contents from this medium
Information for medium named "CD-R"
Medium type code: 11h
Drive recognizes this medium.
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ (10) command with this medium
Device can use the READ (12) command with this medium
Device can use the READ CD command with LBA addressing with this medium
Device can use the READ CD command with MM:SS:FF addressing with this medium
Device can use the READ CD command with LBA addressing with this medium to read raw sector
Device can use the READ CD command with MM:SS:FF addressing with this medium read raw sector
Device can use the PLEXTOR vendor READ DVD (RAW) command with this medium
Device can read the CD Absolute-Time-In-Pregroove from this medium
Device can report the C2 pointers when reading from this medium
Device can correct subchannels when reading from this medium
Device can read the Table of Contents from this medium, without processing it
Device can read the first track's pregap data
Device can read the Power Management Area from this medium
Device can read the P to Q subchannels from this medium
Device can read the P to Q subchannels from this medium reporting the C2 pointers
Device can read the R to W subchannels from this medium
Device can read the Table of Contents from this medium
Information for medium named "CD-ROM"
Medium type code: 01h
Drive recognizes this medium.
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ (10) command with this medium
Device can use the READ (12) command with this medium
Device can use the READ CD command with LBA addressing with this medium
Device can use the READ CD command with MM:SS:FF addressing with this medium
Device can use the READ CD command with LBA addressing with this medium to read raw sector
Device can use the READ CD command with MM:SS:FF addressing with this medium read raw sector
Device can use the PLEXTOR vendor READ DVD (RAW) command with this medium
Device can read the CD Absolute-Time-In-Pregroove from this medium
Device can report the C2 pointers when reading from this medium
Device can correct subchannels when reading from this medium
Device can read the Table of Contents from this medium, without processing it
Device can read the first track's pregap data
Device can read the P to Q subchannels from this medium
Device can read the P to Q subchannels from this medium reporting the C2 pointers
Device can read the R to W subchannels from this medium
Device can read the Table of Contents from this medium
Information for medium named "CD-RW"
Medium type code: 21h
Drive recognizes this medium.
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ (10) command with this medium
Device can use the READ (12) command with this medium
Device can use the READ CD command with LBA addressing with this medium
Device can use the READ CD command with MM:SS:FF addressing with this medium
Device can use the READ CD command with LBA addressing with this medium to read raw sector
Device can use the READ CD command with MM:SS:FF addressing with this medium read raw sector
Device can use the PLEXTOR vendor READ DVD (RAW) command with this medium
Device can read the CD Absolute-Time-In-Pregroove from this medium
Device can report the C2 pointers when reading from this medium
Device can correct subchannels when reading from this medium
Device can read the Table of Contents from this medium, without processing it
Device can read the first track's pregap data
Device can read the Power Management Area from this medium
Device can read the P to Q subchannels from this medium
Device can read the P to Q subchannels from this medium reporting the C2 pointers
Device can read the R to W subchannels from this medium
Device can read the Table of Contents from this medium
Information for medium named "DVD+R"
Medium type code: 41h
Drive recognizes this medium.
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ (10) command with this medium
Device can use the READ (12) command with this medium
Device can use the PLEXTOR vendor READ DVD (RAW) command with this medium
Device can read the DVD ADress-In-Pregroove from this medium
Device can read the Disc Control Blocks from this medium
Information for medium named "DVD+R DL"
Medium type code: 41h
Drive recognizes this medium.
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ (10) command with this medium
Device can use the READ (12) command with this medium
Device can use the PLEXTOR vendor READ DVD (RAW) command with this medium
Device can read the DVD ADress-In-Pregroove from this medium
Device can read the Disc Control Blocks from this medium
Device can read the layer capacity from this medium
Information for medium named "DVD+RW"
Drive does not recognize this medium.
Information for medium named "DVD-R"
Drive does not recognize this medium.
Information for medium named "DVD-R DL"
Drive does not recognize this medium.
Information for medium named "DVD-ROM"
Medium type code: 41h
Drive recognizes this medium.
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ (10) command with this medium
Device can use the READ (12) command with this medium
Device can use the PLEXTOR vendor READ DVD (RAW) command with this medium
Device can read the Copyright Management Information from this medium
Device can read the Disc Manufacturer Information from this medium
Device can read the Physical Format Information from this medium
Information for medium named "DVD-RW"
Drive does not recognize this medium.