Mode | Contents |
---|---|
MODE page 01h |
SCSI Read-write error recovery page: Parameters can be saved Automatic write reallocation is enabled Drive will repeat read operations 5 times Drive will repeat write operations 5 times |
MODE page 02h |
SCSI Disconnect-Reconnect mode page: Parameters can be saved 32 ratio of buffer that shall be full prior to attempting a reselection 32 ratio of buffer that shall be empty prior to attempting a reselection Data transfer disconnect control is not used |
MODE page 08h |
SCSI Caching mode page: Parameters can be saved Write-cache is enabled Drive does not distinguish between cached read data Drive does not distinguish between cached write data Pre-fetch values indicate a block multiplier Pre-fetch will be done for READ commands of 64 blocks or less At least 1 blocks will be always pre-fetched A maximum of 1 blocks will be pre-fetched A maximum of 64 blocks will be pre-fetched even if it is commanded to pre-fetch more |
MODE page 0Ah |
SCSI Control mode page: Parameters can be saved The logical unit maintains one task set for all nexuses Commands should be sent strictly ordered If ACA is established, the task set commands shall resume after it is cleared, otherwise they shall terminate with CHECK CONDITION LUN shall clear unit attention condition reported in the same nexus On medium insertion, it shall be loaded for full access |
MODE page 0Bh |
SCSI Medium types supported page: Parameters can be saved Supported medium type one: a Write-once Read-many optical Supported medium type two: a Erasable optical |
MODE page 20h | Unknown mode page |
MODE page 21h | Unknown mode page |