Mode | Contents |
---|---|
MODE page 01h |
SCSI Read-write error recovery page: Parameters can be saved Automatic write reallocation is enabled Automatic read reallocation is enabled Drive will repeat read operations 8 times Drive will repeat write operations 8 times |
MODE page 02h |
SCSI Disconnect-Reconnect mode page: Parameters can be saved 80 ratio of buffer that shall be full prior to attempting a reselection 80 ratio of buffer that shall be empty prior to attempting a reselection Data transfer disconnect control is not used |
MODE page 03h |
SCSI Format device page: 6 tracks per zone to use in dividing the capacity for the purpose of allocating alternate sectors 32 sectors per zone that shall be reserved for defect handling 0 tracks per zone that shall be reserved for defect handling 0 tracks per LUN that shall be reserved for defect handling 252 physical sectors per track 512 Bytes per physical sector Target-dependent interleave value is 1 21 sectors between last block of one track and first block of the next 27 sectors between last block of a cylinder and first block of the next one Drive supports soft-sectoring format Sector addressing is progressively incremented in one cylinder before going to the next |
MODE page 04h |
SCSI Rigid disk drive geometry page: 2 heads 7068 cylinders Heads park in cylinder 0 Medium rotates at 5400 rpm Spindle synchronization is disable or unsupported |
MODE page 08h |
SCSI Caching mode page: Parameters can be saved Write-cache is enabled Drive does not distinguish between cached read data Drive does not distinguish between cached write data Pre-fetch will be done for READ commands of 65535 blocks or less A maximum of 65535 blocks will be pre-fetched |
MODE page 0Ah |
SCSI Control mode page: Parameters can be saved The logical unit maintains one task set for all nexuses Commands should be sent strictly ordered If ACA is established, the task set commands shall resume after it is cleared, otherwise they shall terminate with CHECK CONDITION LUN shall clear unit attention condition reported in the same nexus On medium insertion, it shall be loaded for full access |
MODE page 0Ch | Unknown mode page |
MODE page 0Dh |
SCSI CD-ROM parameters page: Parameters can be saved Drive will remain in track hold state a vendor-specified time after a seek or read |
MODE page 1Ch |
SCSI Informational exceptions control page: Parameters can be saved Informational exceptions are disabled |
MODE page 20h | Unknown mode page |
MODE page 30h | Unknown mode page |
MODE page 39h | Unknown mode page |
EVPD | Contents |
---|---|
EVPD page 00h | Undecoded |