Aaru Report for
IOMEGA
ZIP 100
14.A
ATAPI characteristics:
ATAPI device
Model: IOMEGA ZIP 100 ATAPI
Firmware revision: 14.A
Supported ATA versions: ATA-2 ATA/ATAPI-4
Maximum ATA revision supported: Minor ATA version not specified
Parallel ATA device:
ATAPI Direct-access device
Device shall assert INTRQ when DRQ is set to one
ATAPI device uses 12 byte command packet
Device capabilities:
IORDY is supported and can be disabled
At minimum 500 ns. transfer cycle time per word in PIO, without flow control
At minimum 500 ns. transfer cycle time per word in PIO, with IORDY flow control
Command set and features:
28-bit LBA is supported
Removable Media Status Notification feature set is supported
Security:
Security is enabled
Security is not locked
Security is not frozen
Security count has not expired
Security level is high
Supports enhanced security erase
0 minutes to complete secure erase
0 minutes to complete enhanced secure erase
Master password revision code: 0
SCSI characteristics:
Vendor: IOMEGA
Product: ZIP 100
Revision: 14.A
Device is connected and supported.
Direct-access device
Device claims to comply with ANSI X3.408:2005 (SPC-3)
Device does not claim to comply with any SCSI ECMA standard
Device does not claim to comply with any SCSI ISO/IEC standard
Device is removable
Device supports setting Normal ACA
Device supports LUN hierarchical addressing
Device does not support asymmetrical access
Device supports only ST clocking
Device supports MODE SENSE (6)
Device supports MODE SENSE (10)
SCSI mode sense pages:
Mode |
Contents |
MODE page 01h
|
SCSI Read-write error recovery page: Automatic write reallocation is enabled Automatic read reallocation is enabled Drive will use the most expedient form of error recovery first Drive will repeat read operations 22 times
|
MODE page 05h
|
SCSI Flexible disk page: Transfer rate: 32768 kbit/s 64 heads 96 cylinders 32 sectors per track 512 bytes per sector Write pre-compensation starts at cylinder 0 Write current reduction starts at cylinder 0 Target shall wait 0 seconds before attempting to access the medium after motor on is asserted Target shall wait 0 seconds before releasing the motor on signal after becoming idle Drive needs to do 1 step pulses per cylinder Medium rotates at 2941 rpm Pin 34 is unconnected Pin 4 is unconnected Pin 2 is unconnected Pin 1 is unconnected
|
MODE page 08h
|
SCSI Caching mode page: Write-cache is enabled Drive does not distinguish between cached read data Drive does not distinguish between cached write data Pre-fetch will be done for READ commands of 65535 blocks or less A maximum of 65535 blocks will be pre-fetched A maximum of 65535 blocks will be pre-fetched even if it is commanded to pre-fetch more
|
MODE page 2Fh
|
Unknown mode page
|
Tested media:
Information for medium named "Zip 100"
Medium type code: 00h
Drive recognizes this medium.
Medium manufactured by: Iomega
Medium model: Zip 100
Logical sector size: 512 bytes
READ LONG sector size: 564 bytes
Medium has 196608 blocks of 512 bytes each
Medium size: 100663296 bytes, 100 Mb, 96.00 MiB
Device can use the READ LONG command in CHS mode with this medium
Device can use the READ CAPACITY (10) command with this medium
Device can use the READ (6) command with this medium
Device can use the READ (10) command with this medium
Device can use the READ (12) command with this medium
Device can use the READ LONG (10) command with this medium