Aaru Report for TEAC CD-211E 3.0E

ATAPI characteristics:
ATAPI device
Model: CD-211E
Firmware revision: 3.0E
Supported ATA versions: ATA-1 ATA-2 ATA/ATAPI-4
Maximum ATA revision supported: Minor ATA version not specified
Parallel ATA device:
PIO timing mode: 2
DMA timing mode: 2
Advanced PIO: PIO0 PIO1
Multi-word DMA: MDMA0 MDMA1 MDMA2 (active)

ATAPI CD-ROM/DVD/etc device
Device shall set DRQ within 50 µs of receiving PACKET
ATAPI device uses 12 byte command packet
0 KiB of dual ported multi sector buffer with read caching
Device capabilities:
Standby time values are standard
IORDY is supported and can be disabled
DMA is supported
ATAPI device supports overlapped operations
At minimum 150 ns. transfer cycle time per word in MDMA, 150 ns. recommended
At minimum 180 ns. transfer cycle time per word in PIO, without flow control
At minimum 180 ns. transfer cycle time per word in PIO, with IORDY flow control
350 ns. typical to release bus from receipt of PACKET
Command set and features:
28-bit LBA is supported

SCSI characteristics:
Vendor: TEAC
Product: CD-211E
Revision: 3.0E
Device is connected and supported.
CD-ROM/DVD/etc device
Device claims to comply with ANSI X3.408:2005 (SPC-3)
Device does not claim to comply with any SCSI ECMA standard
Device does not claim to comply with any SCSI ISO/IEC standard
Device is removable
Device supports setting Normal ACA
Device supports LUN hierarchical addressing
Device does not support asymmetrical access
Device supports only ST clocking
Device supports MODE SENSE (10)

SCSI mode sense pages:
Mode Contents
MODE page 01h SCSI Read error recovery page for MultiMedia Devices:
Drive will repeat read operations 5 times
All available recovery procedures will be used.
Recovered errors will not be reported.
Unrecovered ECC errors will return CHECK CONDITION.
MODE page 0Dh SCSI CD-ROM parameters page:
Drive will remain in track hold state 2 minutes after a seek or read
Each minute has 60 seconds
Each second has 75 frames
MODE page 0Eh SCSI CD-ROM audio control parameters page:
Drive will return from playback command immediately
Output port 0 has channels 0 at maximum volume
Output port 1 has channels 1 at maximum volume
MODE page 2Ah SCSI CD-ROM capabilities page:
Drive can play audio
Drive can read sectors in Mode 2 Form 1 format
Drive can read sectors in Mode 2 Form 2 format
Drive supports multi-session discs and/or Photo-CD
Drive can read digital audio
Drive can continue from streaming loss
Drive can read Media Catalogue Number
Drive can read ISRC
Drive uses a tray
Drive can lock media
Drive is not locked, media can be ejected and inserted
Drive can eject media
Each channel can be muted independently
Each channel's volume can be controlled independently
Drive supports 16 volume levels
Drive has 128 Kbyte of buffer
Drive's maximum reading speed is 2117 Kbyte/sec.
Drive's current reading speed is 2117 Kbyte/sec.

SCSI CD-ROM capabilities:
Drive can continue from streaming loss
Drive can eject media
Drive can lock media
Drive can play audio
Drive can read digital audio
Drive can read ISRC
Drive can read Media Catalogue Number
Drive can read sectors in Mode 2 Form 1 format
Drive can read sectors in Mode 2 Form 2 format
Drive has 128 Kbyte of buffer
Drive is not locked, media can be ejected and inserted
Drive supports 16 volume levels
Drive supports multi-session discs and/or Photo-CD
Drive uses a tray
Drive's current reading speed is 2117 Kbyte/sec.
Drive's maximum reading speed is 2117 Kbyte/sec.
Each channel can be muted independently
Each channel's volume can be controlled independently