| Mode | Contents |
|---|---|
| MODE page 01h |
SCSI Read-write error recovery page: Parameters can be saved Automatic write reallocation is enabled Automatic read reallocation is enabled Data not recovered within limits shall be transferred back before a CHECK CONDITION Drive will use the most expedient form of error recovery first Drive shall report recovered errors Drive will repeat read operations 63 times Drive will repeat write operations 63 times Drive will employ a maximum of 15000 ms to recover data |
| MODE page 02h |
SCSI Disconnect-Reconnect mode page: Parameters can be saved 100 µs maximum permitted to assert BSY without a REQ/ACK handshake Data transfer disconnect control is not used |
| MODE page 03h |
SCSI Format device page: Parameters can be saved 27 tracks per zone to use in dividing the capacity for the purpose of allocating alternate sectors 24 sectors per zone that shall be reserved for defect handling 0 tracks per zone that shall be reserved for defect handling 27 tracks per LUN that shall be reserved for defect handling 107 physical sectors per track 512 Bytes per physical sector Target-dependent interleave value is 1 88 sectors between last block of one track and first block of the next 82 sectors between last block of a cylinder and first block of the next one Drive supports hard-sectoring format Sector addressing is progressively incremented in one cylinder before going to the next |
| MODE page 04h |
SCSI Rigid disk drive geometry page: Parameters can be saved 27 heads 24622 cylinders Write pre-compensation starts at cylinder 0 Write current reduction starts at cylinder 0 Heads park in cylinder 0 Medium rotates at 10025 rpm Spindle synchronization is disable or unsupported |
| MODE page 07h |
SCSI Verify error recovery page: Parameters can be saved Drive will use the most expedient form of error recovery first Drive will repeat verify operations 63 times Drive will employ a maximum of 15000 ms to recover data |
| MODE page 08h |
SCSI Caching mode page: Parameters can be saved Drive does not distinguish between cached read data Drive does not distinguish between cached write data Pre-fetch will be done for READ commands of 65535 blocks or less A maximum of 65535 blocks will be pre-fetched even if it is commanded to pre-fetch more Drive should not reorder the sequence of write commands to be faster Drive should have 8 cache segments |
| MODE page 0Ah |
SCSI Control mode page: Parameters can be saved The logical unit maintains one task set for all nexuses Commands can be reordered in any manner If ACA is established, the task set commands shall resume after it is cleared, otherwise they shall terminate with CHECK CONDITION LUN shall clear unit attention condition reported in the same nexus On medium insertion, it shall be loaded for full access A maximum of 176100 ms are allowed to remain busy |
| MODE page 0Ch | Unknown mode page |
| MODE page 1Ch |
SCSI Informational exceptions control page: Parameters can be saved Informational exceptions are enabled Unconditionally generate recovered error on informational exceptions Drive shall log informational exception conditions Informational exception conditions will be reported a maximum of 1 times |
| MODE page 21h | Unknown mode page |
| EVPD | Contents |
|---|---|
| EVPD page 00h | Undecoded |
| EVPD page C0h | Undecoded |
| EVPD page C1h | Undecoded |